Trolley furnace overhaul Precautions

1 with corrosive, volatile, explosive gases into the furnace processing of the workpiece is strictly prohibited, so as not to affect the heating elements and refractory life and cause explosions and other accidents.
(2) shall not exceed the furnace temperature operation, otherwise it will shorten the life of the equipment.
3 oxide into the blast furnace of the workpiece to be too clear, available under the wire brush.
4 piece uniform stacking, from the heating element should be around 100-150mm.
5 is strictly prohibited barbaric operation, the workpiece should be light, to avoid shocks.
6 used furnace operator must not leave jobs, you must always pay attention to the working conditions are normal furnace.
7 furnace during loading and unloading the workpiece, you must first cut off the heating element power to ensure operator safety.
8 furnace oxides (including electric wire under) should always be cleaned at least once a week or five times a furnace. Furnace blowing with compressed air under the floor.
9. Resistance wire as it used, you can not bend the collision to avoid breakage.
10 furnace motor requiring regular inspection, lubrication, etc., pay attention to the use of safety.
11 at the shaft sleeve must always check lubrication to prevent damage due to lack of oil and bushings.
12. Periodically check the use of the heating element. The heating element is not kinked short-term use after the collision. If you have not heavily corroded and broken, can be used with the electric wire of the same material (or electric wire itself) as an electrode, the use of acetylene gas for heating welding electrodes using 50% Baiyun powder mixture, if the heating element can not be used when severe corrosion, should be replaced.
13 Regular calibration instruments, thermocouple usage prevent instrumentation, thermocouple temperature measurement errors caused by incorrect affect product quality.